MAP= Mean Artery Pressure,
It reflects the blood pressure of an artery when an artey
expands to Its maximum capacity when volume of blood come to an artery.
There is a
Slight difference between the actual measured MAP and the
calculated
Map : This difference can be a reference for doctors or
users.
PP =Pulse Pressure
It is the difference between Systolic and Diastolic BP.
Somewhere It carries meaning in relation to arterial stiffness because
Pulse Pressure = Cardiac Output x Arterial Stiffness
This unit not only has been designed With
Automatic-measurement but
Also optionally with Stethoscope-sounding
measurement Function
Which is almost with same measuring process as
mercurical sphygmomanometer does except display display with digits.
Stethoscope Measuring Step:
The Signal Sound will display on the screen, standby
for sounding mode.
Place the stethoscope chestpiece in the artecubital
space below the cuff.
Press M.RECALL button again, the motor will start pumping
and inflate to high pressure(around 190 mmHg) then start exhausting at
an auto pre-set rate during stethoscope sounding measuring, until the
end of the measurement. Meanwhile, use the bell side of a combination
Stethoscope for clearest detection of Systolic BP and Diastolic BP.
The motor can be pumped up again by continuously pressing
M.RECALL button button for repeat Stethoscope sounding
measurement
Measurement Method:
Oscillometric
Measurement Range :
Pressure - 20 ~ 280 mmHg
Pulse rate
40 ~ 200 beats/min
Accuracy:
Pressure -+--
3 mmHg
Pulse rate -+--
5% of reading
Memory: 90
Memories or 6x90 Memoriies
Power Supply: DC 6V, AA 1.5V X 4
batteries
Display: Large Digit LCD
Oper. Temp./ Humidity:
+10C to +40C, 40% to 85% RH
Storage Temp./Humidity:
-10C to +60C, 10% to 95% RH
Weight of Main Unit:
Approx. 650g (ex. batteries)
Certificate
1. FDA
510(K) approval
2. CE 0434 approval
3. RoHs compliance
4. EMC Test Report
5. GMP
For your clinical test measurement must issue DIN Standard committee
for non-invasive sphygmomanometers.
If you test measurement one time must be rest 3
minute, Would you please can not continuous test measurement
Or Please rest for three minutes in between
measurements.
Periodical Re-calibration:
Sensitive measuring devices must from time to time be checked for
accuracy,
We
therefore recommend a periodical inspection of the static pressure
display every 2 years. Your specialist dealer would be pleased to
provide more extensive information about this.
Calibration is recommended every two years
Specifications are subject to change for improvement without notice.
Ordering: 2,000pcs
F.O.B.
KEELUNG, TAIWAN PORT
HERS
MEDICAL CO., LTD
|
Home |
Company
| Showroom|
Awards |
Factory |
Technology |
Inquire |Chinese
